E165GB — Technische Informationen

HARDWARE HARDWARE 4.9. External program selection 5. The KUAX 671 PG hand terminal It is possible to set up the system for external program selection in addition to selecting the program at the hand terminal. A terminal stip with supplementary inputs is used for this purpose. ‘The desired program number can be entered in binary code using three input terminals (pins 1 to 3). The program is then started with a supplementary push-button contact which is connected at pin 6. The 24 V required for the selection routine is available at pin 7. 5.1. General is enclosed in a sturdy and convenient ‘The hand terminal for the KUAX 671 elements are compact but easy t0read plastic case.

The display and control A key switch should be used to secure the program start button; this will and use and are arranged for industrial use. eliminate the possibility of an inadvertent change of programs. ‘We recommend the use of a BCD switch to encode the program selection. ‘The terminal carries out essentially three functions: Note: After switching the power supply on, always the program number selected last is set. lo lug hn | 7 - Calling up the programs thus generated operation into unit the putting when controller thecam -Initializing Extemal program-preselection Program No. es programming.

The operator is ‘The two-line, 16-character display simplifi proceduhres by menus in most cases. oug ead thrthe [2° |2" -|— 6 x ‘26V0C mi Poe - Program generation x ‘The program generation is logical and uncomplicated.It is carrioutedby using a Frch-pad key panel. Assigning multiple functions to the keys was avoided wherever possible. =xx ‘The program number is always shown in the display as well as the encoder position and the status indicators for the outputs. _— q \ so that ‘The hand terminal is fitted with an internally buffered memory programs can also be transferred to other cam controllers.

x= switch closed external Program-preselection acid Lc Initialization For installing the hand terminal a bracket can be used. A mounting frame makes a front panel fitting possible (cf. ch. 6.2.1.). Start, external program-preselection of switch on/off output function A.25 meters long cable is used to make the connection to the cam controller. 4.10. Special functions by external selection Input Pin 4: Any angle position of the encoder can be initialized as zero point via pin 4 (active 24 V DC) at any time. Input Pin 5: The outputs can be switched off via pin 5 (outputs active = 0 V DC). 13 15