6.2.1. Mounting and front panel fitting Mounting frame front panel fitting HARDWARE 7. The absolute ¢.ncoder systems 7.1. General The KUAX 671 electronic cam cot 7 abso! encoder to sense the absolute posit jon of acan wheel peopernyeters must operate with a modified Gray, code, Here the level of only a singledatadata come an ach pulse. Di a transmission is in :parallel; nine ‘ Hoe jines 8 are used at 180/360 pulses/re’ se puisenice. v., whereas ten data lines are required for 7.2. Selecting the dire tion of rotation rotain ( rection of , An additional data line is required oe kwise amttcloc or whether ack ¢ CPS einstalled made withdu inga "iBhookScivis is upward ion).
theTheunitchangecounts inside the cam switch ge rotation), controller (see section 3.3). i i Important: : The unit must be swit shed off before changing the setting of the must switches hook the several P2 (rajie} controls, If there k switch. same areposition. be in the always TUNG operating voltage iS: sy ptied to the encoder by the KUAX _ yar; ‘The connection cable is available i ,"3700s leneths aed i tned KUAX 671 at a 25pole D-SUB pi the ‘The extension of the connector cat ye j¢ jimited to a maximum length of 20 meters. Mounting frame bracket 7.3. Encoder types ‘The following encoder types ae U seq for the time being:
Absolute angle encoder, 180/360 p Shifting possible by software (withie, Absolute angle encoder, 1000 puls = (orithout connecting cable) esirev. ONE Neer 2098} Order No. 671.359.03 For Connecting cable and accesso! ies cf, Order Information!! 23