E165GB — Technische Informationen

OPERATION TESTS INDICATORS AND MALFUNCTION OPERATION TESTS INDICATORS LED signal ‘The short-circuit indicator for the outputs will normally not be lit up. KS/Batt LED blinking. The cam controller will be switched off and the RUN indicator light goes out. The short-circuit control light will also blink if the supply voltage to the electronic cam controller falls below the acceptable minimum level. ‘Once the problem has been eliminated the RUN lamp will light again when the supply voltage is switched on. blinks Cause case the battery must be replaced by a new one without switching the control Short cir- cuit at s output * A00= deactivated Low vol- i :

uae lit permane é lights up if an error is detected in the program currently being run. The - outputs are being switched off. The fault indicator stays on even if you Reaction of the control lit permanently change to another program. The fault indicator is reset with the CTRL 2 All outputs are switched off. The green RUN-LED goes out. _ Measure: remove cause; switch deactivated control back on. All outputs are switched off. The tage at green RUN-LED goes out. supply voltage Measure: remove cause; switch control back on. Buffer bat The LED isa warning. ‘The battery has to be replaced by a new. one aoe: ~ 11.2.3. Parity check (red LED) ‘The parity check indicates errors in the program memory.

The red LED |_ Parity Models with a Lithium battery check the charge of the battery. If the battery is too discharged, this is indicated by the permanently lit up LED. In this off. MALFUNCTION 11.2.4. Malfunction indicators overview 11.2.2. KS/BATT (short-circuit) indicator (red LED) If there is a short at one of the outputs, however, this is indicated by this AND within 4 weeks, The LED then goes ged enoughout automatically. Error in current All outputs are switched off. The green RUN-LED stays on. program Measure: delete current program and load a new one. Encoder ‘The function remains active up to function.

‘The KUAX 671 PG hand terminal offers you the capability to have the Parity error displayed (see Malfunction messages at the hand terminal). Ifa parity error occurs, the according program has first to be deleted using the "DEL" key and then must be reprogrammed or existing programs have to be copied respectively. - rotation rotation speed too high. With speed dyn. models only. 150 % of the rotation speed allowed; the resolution is reduced, however. *A0l deactivated * Only valid for models with report output (671.022.XX). 53 52