32 en Preparing milk froth Maintenance and daily cleaning Ў Risk of electric shock Unplug the appliance before cleaning it. Never immerse the appliance in water. Do not use a steam cleaner. Ў Risk of burns The milk frother (6) gets very hot. Hold the milk frother (6) by the plastic part only. Tip: You can foam the milk fi rst and then dispense coffee, or foam the milk separately and pour it onto the coffee. ●Wipe the outside of the appliance with a soft, damp cloth. ●Do not use abrasive cloths or cleaning agents. The appliance must be ready for use with the cleaned milk frother attached. 1. Press the h button (11). The h button (11) fl ashes and the appliance now heats up for approx.
20 seconds. The display then shows Pull milk frother . 2. Immerse the milk frother so that it reaches the bottom of a cup or glass that is one-third fi lled with milk. 3. Pull the milk frother (6) to open it. ●Always remove any limescale, coffee, milk or descaling fl uid residue immedi- ately. Such residue can cause corrosion. New sponge cloths may contain salts. Salts can cause rust fi lm on stainless steel and must therefore be washed out thoroughly before use. ●Pull the drip tray (8c) with the coffee grounds container (8b) forward and out. Remove the panel (8a) and the grate (8d). Empty and clean the drip tray and coffee grounds container. ●Remove drawer (4) and clean.
Ў Risk of scalding Splashes of milk can scald. Do not touch the outlet (6a) or aim it at anyone. 4. Close milk frother (6) by pushing it in. Tip: For optimal milk froth quality, use cold milk with a fat content of at least 1.5 % if possible. Important: Dried milk residue is diffi cult to remove, so the milk frother (6) must be cleaned with lukewarm water immediately after use and rinse using the Rinse milk system programme (see page 33). Robert Bosch Hausgerдte GmbH TES55236RU.indb 32 04.06.2013 14:35:45