Department of Defense MIL-STD-1311C — MIL-STD-1311C Test Methods for Electron Tubes – DoD Standard PDF

Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 METHOD 4231A ELECTRONIC TUNING HYSTERESIS (Klystron oscillators) 1. Purpose. This test is a measurement of electronic tuning hysteresis in klystron oscillators. 2. Definition. Electronic tuning hysteresis is present in a klystron oscillator when, with the same set of operating conditions, the output power and operating frequency can have more than one value (including zero) for the same electronic controlling voltage. 3. Equipment. a. Power supplies to provide normal operating voltages and currents. b. Means to vary the controlling voltage, dynamically and statically. c.

Means to observe the output power as the controlling voltage is varied; such as a microwave diode (crystal rectifier) and a cathode-ray oscilloscope. d. Means to observe or check the output frequency, such as a tunable frequency meter. 4. Procedure. a. The measurement of electrical-tuning hysteresis shall be made with test condition voltages applied and the frequency of oscillation adjusted to the value specified. b. In addition to the direct voltage required for the mode specified, a low-frequency sweep voltage of essentially sinusoidal shape, sufficiently large to suppress oscillations on the two ends of the sweep, shall be applied between the controlling electrode and the cathode. c.

A loosely coupled portion of the klystron output shall be detected by a suitable microwave diode (crystal rectifier). d. The crystal-rectifier current shall be examined as a function of the sweep voltage with a cathode-ray oscilloscope, and any interval over which oscillation is observed for one direction of sweep only is said to exhibit hysteresis. 5.1 Hysteresis (1). The ratio of the voltage interval or intervals in which hysteresis is present to the voltage interval in which oscillation is observed shall not exceed the amount specified. 5. Acceptance criteria. FIGURE 4231-1. Hysteresis (1). METHOD 4231A 25 March 1970 4231-1