Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 METHOD 4259 INCREMENTAL GAIN (Microwave amplifier tubes) 1. Purpose. To measure incremental gain in microwave amplifier tubes. 2. Definition. Incremental gain is the ratio of (1) the change in rf output power, to (2) a specified small change in rf drive power at a stated driving or output power level. 3. Equipment. Use circuit in method 4253 for measurement of gain. 4. Procedure. 4.1 The tube is operated in accordance with the voltages, stated driving or output power, and conditions specified in the TSS.
The rf drive power is changed by the amount specified in the TSS, and the corresponding change in rf output power is recorded. The ratio of change in rf output power to the change of rf drive power is incremental gain expressed in dB. Pin Pout dB gain l Incrementa log 10 ) ( 4.2 The incremental gain shall be within the limit(s) as specified in the TSS. 5. Precautions. 5.1 Operating voltage fluctuations should be minimized so their effect on the measured results are negligible. 5.2 It is important that the measuring systems contain harmonic filters. METHOD 4259 4259-1 13 September 1972