Department of Defense MIL-STD-1311C — MIL-STD-1311C Test Methods for Electron Tubes – DoD Standard PDF

Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 METHOD 5411 RESOLUTION, VISUAL OUTPUT (Cathode-ray charge storage tubes) 1. Purpose. The purpose of this test is to measure the quantity of information that may be written in and read out of a storage tube. 2. Equipment. a. The writing-deflection system shall produce a raster of essentially parallel equally-spaced lines written at the sweep speed(s) and at the frame rate(s) as specified in the TSS. The spacing between the lines shall be adjustable. b. External focus and deflection components when used shall be located with respect to the TUT as specified in the TSS. c. The TUT output shall be monitored visually. d.

A photometer shall be used to measure the luminance of the TUT over a circular area 10 5 mm (approximately .4 .2 inch) in diameter, or as specified in the TSS. 3. Procedure. a. Operating voltages and conditions shall be within the limits specified in the TSS. b. The raster repetition frequency, the total number of superimposed rasters, the scanning speed, and the erase conditions (when applicable) shall be as specified in the TSS. c. The resolution shall be measured at the luminance value(s) and at the faceplate location(s) specified in the TSS. d. Unless otherwise specified in the TSS, focus shall be adjusted for optimum at the location(s) under test. e.

When examining the output display, the TUT shall be written at the location(s) specified in the TSS; then erased and rewritten with the lines spaced progressively closer until the individually written raster lines first merge into a uniform brightness. The shrinking raster resolution is then equal to: N (WRSL/raster height) h merged raster. Where: N is the number of scan lines written. h is the written raster height. WRSL is the written raster scan line. (For multigun tubes, writing, reading, and erasing may be simultaneous or sequential. For single gun tubes, these operations are performed sequentially.) f. When specified in the TSS, the test should be repeated with the raster rotated 90 .

A single compromise focus condition shall be used. METHOD 5411 5411-1 12 December 1972