Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 4. Precautions. a. To assure that stray light sources do not significantly affect luminance measurements, the light level recorded by the photometer in the measurement position shall be such that, with the TUT off, the photometer reading does not exceed 3 percent of the TUT luminance value to be measured. b. The individual lines of the written raster are readily discernible at large spacings but blend into a relatively uniform brightness as the spacing between written lines is decreased.
It is essential to determine the condition where the written lines first merge in the specified faceplate location(s), before measuring the raster height (h). Shrinking the raster beyond the first-merge condition may give a false indication of line separation and subsequently result in a second-merge condition which will give an erroneous raster height measurement. 5. TSS requirements. The TSS shall specify the following. 5.1 Equipment. a. Sweep speed(s) and frame rate(s) (see 2a). b. When used, external focus and deflection component locations (see 2b). c. The area of the photometer measurement, only if it is to be other than as specified in 2d. 5.2 Procedure. a.
Limits of operation voltages and conditions (see 3a). b. The raster repetition frequency, the total number of superimposed rasters, the scanning speed, and the erase conditions (when applicable) (see 3b). c. Luminance value(s) and faceplate location(s) at which resolution shall be measured (see 3c). d. Focus adjustment, only if it is to be other than optimum (see 3d). e. Location(s) at which rasters shall be written (see 3e). f. Whether or not the test should be repeated with both rasters rotated 90 (see 3f). METHOD 5411 12 December 1972 5411-2