Тексел ТХ01-RS — 7.1 Setup sequence

7 Configuration 7.1 Setup sequence The Setup mode is intended for viewing and editing the device parameters. New parameters are saved to non-volatile memory of the device. To enter the setup mode, press and hold the button Using , and enter the password, and then press for at least 2 seconds. and . If the password is 0 (default), press . NOTICE If you forgot your password, you can enter the settings mode using the password 1098 ! Further password changes are available only on the RS-485 network. If no button operations are performed within 2 minutes:

• when editing a parameter, the device automatically restores its value and returns to the parameter viewing mode; • when setting the parameter, the device automatically returns to tachometer mode. Device settings and the possible values of each of the parameters are presented in Figures 7.1– 7.4 and in Appendix A . NOTICE Upon entering the settings menu, the device does not stop functioning in the operating mode (it continues to measure the time interval between pulses, counts the operating time, controls the operation of the output). 36