Тексел ТХ01-RS — 7.4 Configuring the device from a PC

Figure 7.10 – Principle of generating the output signal in the recorder mode (output of type И) Figure 7.11 – Principle of generating the output signal in the recorder mode (output of type У) 7.4 Configuring the device from a PC To configure the device with a PC, communication interfaces RS-485 is used. The device supports two communication protocols: MODBUS RTU and MODBUS ASCII. Addresses, names and lengths of the device parameters are given in Appendix A . To go to the device settings from a PC, press and hold the and buttons for at least 2 seconds. Then use the is 0 (default), press , and . buttons to enter the password, and then press and . If the password 47