Chapter 2 Setup 5 If the printed lane ID is correct, push the Lane setting button. The printer stores the set lane ID and the IP address and ends the lane ID setting mode. Push the Self-test button to cancel the set lane ID. Then the printer ends the lane ID mode. If 30 seconds or more elapses without any operations while the printer waits for user operation in the lane ID setting mode, the printer discards the set value and ends the lane ID setting mode. Setting the Printer IP Address Connect the printer to the network via a hub using the Ethernet cable. This setting is necessary only for the Ethernet interface model. Set an IP address to the printer with EpsonNet Config.
You can download EpsonNet Config from the following URL. http://download.epson-biz.com/?service=pos 2 When Ethernet cables are installed outdoors, make sure devices without proper surge protection are cushioned by being connected through devices that do have surge pro- tection. Otherwise, the devices can be damaged by lightning. Do not plug an ordinary telephone line into the Ethernet connector. CAUTION Make sure the Ethernet cable is connected to the printer, and the printer is turned on. 45