Appendix Appendix Product Specifications Printing Specifications dpi: dots per inch • The print speed changes automatically depending on the applied voltage, head temperature, and print density. • The maximum print speed may not be reached depending on the data transmission conditions and combination of commands. • When the printing speed fluctuates or intermittent printing occurs due to data transmission conditions, variations in print density or white streaks may occur. • The image quality of barcodes may be degraded depending on the paper you are using. Please print in advance to check if there is any problem with the quality of the barcode.
If there is a problem, reduce the printing speed (recommended: 90mm/s) or increase the size (module size) to ensure the barcode quality. • Liner-free label paper using adhesive may cause disturbance in the paper feed pitch due to changes in the peeling force of the paper from the roll paper. If you use such label paper, please check for any problems beforehand.
119 Printing method Thermal line printing Dot density 0.125 × 0.125 mm/dot (203 × 203 dpi) Paper feed Frictional feeding Paper width 40 mm 58 mm 80 mm Printing width 35 mm {1.38"}, 280 dots 52.5 mm {2.07"}, 420 dots 72.0 mm {2.83"}, 576 dots The number of characters Font A Font B 23 35 42 (42 characters mode) 48 (standard characters mode) 31 46 55 (42 characters mode) 64 (standard characters mode) Maximum print speed • Up to 170 mm/s • Up to 90 mm/s when printing ladder barcodes or two-dimensional symbols • Up to 25 mm/s when Number of head energizing parts is set to 4 divisions. Line spacing 3.75 mm {1/5"}