Chapter 4 Advanced Usage Network tethering • Disabled (initial setting) • Enabled Paper width • 58 mm/80 mm (initial setting) • 40 mm/80 mm When changing from 80 mm wide paper to 58 mm wide paper, the paper width is automatically detected and no setting is required. User NV Memory 1 KB, 64 KB, 128 KB, 192 KB Initial setting: 1 KB NV Graphics Memory None, 64 KB, 128 KB, 192 KB, 256 KB, 320 KB, 384 KB Initial setting: 384 KB Print density Selectable from 70 to 130% (in 5% increments) Initial setting: 115% To ensure good print quality, it is recommended to set the print density according to the paper to be used.
( "Recommended Print Density for Certified Base Paper" on page 124) • The higher the print density is set, the more likely the print speed will decrease. • The higher the print density is set, the more likely it is that paper dust will adhere to the surface of the print head, resulting in blurred printing. Print speed Selectable from levels 1 to 11 (Slow ~ Fast) Initial setting: level 11 Depending on the printing conditions, such as print duty, head temperature, and data transfer speed, the print speed may be adjusted automatically and may cause white streaks on printouts due to intermittent printing (the motor stops occasionally during printing).
To prevent this, set the print speed to a lower speed. Thai Character Composition • Thai 1 pass (initial settings) • Thai 3 pass 82