Chapter 4 Advanced Usage Software Setting Mode (Customize Value Settings) Set the printer's memory switches and customized values. For available settings and explanation of each setting, see "Software Settings" on page 78 . You can also make the software settings using the ESC/POS commands. Follow the steps below. 1 After running a self test, hold down the Feed button for at least one second to enter the Mode selection. The Mode selection guidance is printed, and the Paper LED flashes. 2 Briefly press the Feed button three times (less than one second) , and then hold it down for at least one second to enter the Software settings mode (Customized value setting).
The Software setting mode guidance is printed, and the Paper LED flashes. Customize Value Settings Modes 0: Exit 1: Print Current Settings 2: Print Density 3: Print Speed 4: Automatic Paper Reduction 5: Auto Paper Feed&Cut at cover close 6: Paper Width 7: Character/Font Settings 8: Interface Selection 9: Interface Settings 10: Command Execution (Offline) 11: Other Settings Select Modes by executing following procedure. step 1. Press the Feed button less than 1 second as many times as the selected mode number. step 2. Press Feed button for 1 second or more. 96