Settings Select from the menu list on the left to check or configure the settings. Enable the time server when using a certificate. Otherwise, the printer's Stored Date/Time may not be set correctly and the wireless LAN may be unavailable. If this happens, enable the time server, or initialize the Stored Date/Time from one of the following: EpsonNet Config EpsonNet Config (Web Version) Wireless module setup mode You can check the printer's Stored Date/Time from the dynamic status sheet. Information menu You can check the settings as shown in the table below.
70 Menu Settings Basic Information Administrator Name, Location, interface Card Model Name, MAC Address, Hardware Version, Software Version, Model Name, Communication Standard, Network Mode, SSID, Channel, Transmission Rate, Access Point MAC Address, Signal Condition, Printer Status TCP/IP IPv4 Address IP Address Settings (Acquiring the IP Address, IP Address, Subnet Mask, Default Gateway) Set Using Automatic Private IP Addressing (APIPA) DNS/DDNS DNS Server Addresses (IPv4) Settings (Acquire DNS Server Address Auto- matically, DNS Server Addresses) Domain Name Setting (Acquire Domain Name Automatically, Fully Quali- fied Domain Name, Register the Network Interface’s Address to DNS Server) SNMP Community (Read Only, Wellknown Community Name) IP Trap (Trap1/2, Address, Community) Bonjour Bonjour (Disable/Enable) Bonjour Name, Bonjour Printer Name, Location Time Setting Use Time Server Time Server Address, Update Interval, Time Server Status Timeout Print (LPR, RAW (Port9100)) ePOS-Print Version, ePOS-Print (Disable/Enable), Device ID