[Roaming] and [AP Density] in the [Wireless] menu can be set only when the Wi-Fi model's firmware is version 1.17 or later. [Wellknown Community Name] in the [SNMP] menu can be set only when the Wi-Fi model's firmware is version 1.19 or later. The initial value is enabled. If you disable this setting, there are the following restrictions. TM drivers The battery status cannot be acquired. Port opening is extended by approximately 2 seconds. Deployment Tool The model name cannot be acquired. EpsonNet Config/Monitoring Tool The model name, status, and setting information cannot be acquired. The setting cannot be changed.
You can also select the following functions from the optional configuration menu. Administrator Information : Use to register administrator name and the printer location. Reset : Use to reset the interface card or restore the default settings. Password : Use to change the password. The default setting for the password varies depending on the Wi-Fi model's firmware version. You can check the Wi-Fi model's firmware version using the self-test. ( "Self-test mode" on page 57) You can check the product's serial number using a self-test or on the manufacturing nameplate attached to the product.
( "Self-test mode" on page 57) Certificate Import v Enable the time server when using a certificate. Make the following settings in the Authentication - Certificate Import menu. 1 Set the file type of certificate. 2 Specify the certificate file to import. 3 If the file type of certificate is PKCS#12, enter the password. 4 Click [Import]. 72 Wi-Fi model's firmware version Password Before 1.30 "epson" 1.30 or later Product serial number (10 alphanumeric characters, case sensitive)