Chapter 3 Advanced Usage Condition for BUSY Receive buffer full/Offline (default setting) Receive buffer full In either case above, the printer enters the BUSY state after power is turned on, and when a self- test is being run. If BUSY condition is set to “Receive buffer full,” the printer will not become BUSY When the roll paper cover is open When paper is fed by the FEED button When printing has stopped for a paper out When macro execution ready state When error has occurred Print density Selectable from levels 1 to 7 (Light ~ Dark) Default setting:
Level 4 Depending on the paper type, it is recommended to set the print density as shown in the table below for the best print quality. When the print density level is increased, print speed may be reduced. Print speed Selectable from levels 1 to 13 (Slow ~ Fast) Default setting: Level 13 Depending on print conditions, such as print duty, thermal head temperature, and data transmission speed, print speed is automatically adjusted, which may cause white lines due to intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower.
USB class Vendor-defined class (default setting) Printer class 28 Original Paper type Density TF50KS-EY Level 4 PD160R Level 4 KT48FA Level 4