Chapter 3 Application Development Information Receipt Enhancement Information Print Mode You can confirm the following information by running the R/E information mode: • Automatic top logo setting • Extended settings for automatic top/bottom logo • Automatic bottom logo setting Starting the R/E information print mode Follow the steps below to run this mode. 1 Close the roll paper cover. 2 While pressing the Feed button, turn on the printer. (Keep pressing the Feed button until the printer starts printing.) The printer starts printing current status of the printer.
With the Ethernet interface, before printing starts, it takes 15 seconds if the IP address is fixed and 20 seconds if the IP address is obtained with the automatic setting. (It may take longer, depending on the response time from the host.) 3 When the printer finishes printing the printer status, the following message is printed and the Paper LED flashes. (The printer is now in the self-test wait mode.): “Select Modes by pressing Feed button. Continue SELF-TEST: Less than 1 second Mode Selection: 1 second or more” 3 Press the Feed button. (Keep pressing the Feed button until the printer starts printing.) The printer starts printing instructions. 4 Press the Feed button twice.
5 Then press the Feed button. (Keep pressing the Feed button until the printer starts printing.) The printer starts printing the R/E information. Turn the power off and on to return to the normal mode. 73