In the memory switch setting mode, you can set the following memory switches. • Receive buffer capacity • BUSY condition • Processing when data receive error • Auto line feed • USB power-saving function • Release condition of receive buffer BUSY • Roll paper width • Print density • Print speed • Character code table default • International character default • Number of columns • Autocutting after closing cover • Font replacement • Optional buzzer • Communication condition of USB interface • Communication condition of serial interface Starting the memory switch setting mode Follow the steps below to run this mode. 1 Close the roll paper cover.
2 While pressing the Feed button, turn on the printer. (Keep pressing the Feed button until the printer starts printing.) The printer starts printing current status of the printer. With the Ethernet interface, before printing starts, it takes 15 seconds if the IP address is fixed and 20 seconds if the IP address is obtained with the automatic setting. (It may take longer, depending on the response time from the host.) When the printer finishes printing the printer status, the following message is printed and the Paper LED flashes. (The printer is now in the self-test wait mode.): “Select Modes by pressing Feed button. Continue SELF-TEST: Less than 1 second Mode Selection:
1 second or more” 3 Press the Feed button. (Keep pressing the Feed button until the printer starts printing.) The printer starts printing instructions. 4 Press the Feed button three times. 74 Memory Switch Setting Mode