5.2 Charging Note: Before charging a battery, please refer to the manual by its manufacturer to determine its technical specifications. 1. Take the clamp cable. Connect one end to the Output Port on the back of T120A, and connect the other end (the two clamps) to the battery terminals. The positive clamp (red) goes with the positive terminal, and the negative clamp (black) goes with the negative terminal. 2. On the homepage, press or to choose the “Work Mode” option, and then press to go to the charging mode page. Press or to choose the charging mode that you need and then press . Then set up the charging parameters. Please refer to the technical specifications of the battery to be charged.
For more information, please see 4.2.1 Multiple Charging Modes. 3. Press to start charging. When the battery is fully charged, T120A will stop charging automatically. During charging, if you press , it will stop charging. If you press it again, it will resume charging. During charging, if you press and hold for 3 seconds, it will stop charging and go back to the homepage. EN | 009 EN | 013