2. PRINTER SETUP ENGLISH VERSION EO1-33097 2.8 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities 2.8.2 Self Print Test and Dump Mode 1. Turn off the printer power and install a full width media roll (104mm/4inch) in the printer. 2. Press and hold the [FEED] Button while turning on the printer. The status lamps (LED 1 and LED 2) will light up in the following order: Orange Green Other colour sequences 3. Release the [FEED] Button when LED 1 lights in orange and LED 2 lights in green. 4. Press the [FEED] button. 5. The printer prints the self print test, and then enters Dump Mode. 6. To return to Online operation, turn the printer off, then on again.
Print test label sample NOTE : The following commands will have no effect the test print. D, AX, XS, Z2;1, Z2;2 (only the AY command will) B-FV4D-G PRINTER INFO. PROGRAM VERSION 05MAY2014B-FV4 V1.1J TPCL VERSION 28APR2014 V1.0K CG VERSION 27FEB2014 V1.0 CHINESE VERSION 27FEB2014 V1.0 CODEPAGE VERSION 27FEB2014 V1.0 BOOT VERSION V1.1C KERNEL FONT VERSION 1.0.03 WLAN MODULE [Installed] BLUETOOTH MODULE [Installed] [PARAMETERS] HW DETECT [0000000000000000] TONE ADJUST(T) [---] TONE ADJUST(D) [+00] FEED ADJUST [+0.0mm] CUT ADJUST [+0.0mm] BACKFEED ADJUST [+0.0mm] X-COORD. ADJUST [+0.0mm] CODEPAGE [PC-850] ZERO SLASH [0] FEED KEY [FEED] EURO CODE [B0] CONTROL CODE [AUTO] MAXI CODE SPEC.
[TYPE 1] SENSOR SELECT [Transmissive] PRINT SPEED [5ips] FORWARD WAIT [ON] AUTO CALIB. [OFF] MULTI LABEL [OFF] AUTO THP CHK [OFF] BASIC [OFF] Reserved item1 Reserved item2 FLASH ROM [16MB] SDRAM [32MB] USB SERIAL NUM. [000000000001] [INFORMATION] INFORMATION [B-FV4D-GS12-QM-R] [2303A000006] TOTAL FEED1 [0.00km] TOTAL FEED2 [00000cm] [0000.0inch] TOTAL PRINT [0.00km] TOTAL CUT [0] [RS-232C] BAUD RATE [9600] BIT [8] STOP BIT [1] PARITY [None] FLOW [XON/XOFF] E2-16