2. PRINTER SETUP ENGLISH VERSION EO1-33094 2.3 Loading Supplies 2.3.2 Loading the Ribbon (Cont.) 3. Push Ribbon along the Ribbon Shafts to a position where the ribbon is fully to the Left against the stoppers when fitted. 4. Lower the Print Head Block and set the Ribbon Shaft Holder Plate aligning its holes with the Ribbon Shafts. 5. Take up any slack in the ribbon. Wind the leading tape onto the ribbon take-up roll until the ink ribbon can be seen from the front of the printer. 6. Turn the Head Lever to Label or Tag position to close the Print Head. 7. Close the Top Cover. Ribbon Shaft Holder Plate E2-11 Rib