beckhoff TS1110 — 8 FAQs (frequently asked questions)

FAQs (frequently asked questions) Solution: Please check whether symbols have been created in the simulation PLC and that these can also be used, as the code creator ignores unused symbols during compilation. Calls of program POEs are not created in the simulation PLC, they will possibly have to be retrospectively taken care of. . Make sure that the used symbol address ranges are big enough. The PLC Control Compiler creates the following error message: Error: Variable 'X' to large for address %ADDRESS In this case increase the memory in the project options of the relevant PLC project.

When the simulation PLC project has been compiled without any errors, the symbols in the simulation manager can be updated at the corresponding PLC node with "Re-load". TS1110 81 Version: 1.0