beckhoff — 11.3.10.1.1 Advanced Settings Dialog

Reference | Boxes Startup Checking: The user can specify which slave information should be checked by the master during startup. Check Vendor Ids: If this box is checked, the master checks if the vendor id of the slave device is the same as the configured one. Check Product Codes: If this box is checked, the master checks if the product code of the slave device is the same as the configured one. Check Revision Numbers: If this box is checked, the master checks if the revision number of the slave device is the same as the configured one. Check Serial Numbers: If this box is checked, the master checks if the serial number of the slave device is the same as the configured one. State Machine:

Auto Restore States: If this box is checked, the EtherCAT master tries to restore the state of the slave automatically. If an EtherCAT slave device changes from error state (ERR SAFE-OP, ERR OP etc.) to a valid state (SAFE-OP, OP etc), the EtherCAT master tries to set the device to the current state of the master. ReInit after Comm. Error: If this box is checked, the master sets the Slave back to the "Init" after an communication error. Process Data: Use LRD/LWR instead of LRW: If this box is checked, a LRD (Logical Read) command is used for reading out the inputs of this device and a LWR (Logical Write) command is used for writing data to the outputs of this device.

Otherwise a LRW (Logical Read Write) command is used for reading out the inputs and writing data to the outputs. Include WC State Bit: If this box is checked, a input variable is added to the slave device, that shows the working counter state of the EtherCAT slave device : FMMU/SM Dialog The "FMMU/SM" dialog displays the current configuration of the FMMUs and Sync Managers and allows the user to change these configurations. TwinCAT 2 367 Version: 1.7