Editors ^Between the parentheses of the coil or between the straight lines of the contact, a slash will appear ((/) or |/|). If there are jumps, returns, or inputs or outputs of EN POUs , a small circle will appear at the connection, just as in the FBD editor. The coil now writes the negated value of the input connection in the respective Boolean variable. Right at this moment, a negated contact switches the status of the input to the output, if the respective Boolean variable carries the value FALSE. If a jump or a return is marked, then the input of this jump or return will be negated. A negation can be canceled through renewed negation.
'Extras' 'Set/Reset' If you execute this command on a coil, then you will receive a Set Coil. Such a coil never overwrites the value TRUE in the respective Boolean variable. This means that once you have set the value of this variable to TRUE, it will always remain at TRUE. A Set Coil is designated with an "S" in the coil symbol. If you execute this command once again, then you will be given a Reset Coil. Such a coil never overwrites the value FALSE in the respective Boolean variable. This means that once you have set the value of this variable to FALSE, it will always remain at FALSE. A Reset Coil is designated with an "R" in the coil symbol.
If you execute this command repeatedly, the coil will alternate between set, reset and normal coil. ‘Extras’ ‘Open instance’ This command corresponds to the 'Project' 'Open instance' command. The Ladder Diagram in the Online Mode In Online mode, the contacts and coils in the Ladder Diagram that are in the "On" state are colored blue. Likewise, all lines over which the "On" is carried are also colored blue. At the inputs and outputs of function blocks, the values of the corresponding variables are indicated. Breakpoints can only be set on networks; by using stepping, you can jump from network to network.
If you place the mouse pointer briefly above a variable, then the type and the comment about the variable will be displayed in a Tooltip. 5.8 Continuous Function Chart Editor (CFC) It looks like a block which has been produced using the continuous function chart editor (CFC): TX1200 141 Version: 1.3