Visualization Click on the desired starting point of your element and move the pointer with pressed left mouse key until the element has the desired dimensions. If you want to create a polygon or a line, first click with the mouse on the position of the first corner of the polygon resp. on the starting point of the line, and then click on the further desired corner points. By doubleclicking on the last corner point you will close the polygon and it will be completely drawn respectively the line will be completed. If you want to create a curve (Bezier curves) determine the initial and two other points with mouse clicks to define the circumscribing rectangle.
An arc is drawn after the third mouse click. You can then change the position of the end point of the arc by moving the mouse and can then end the process with a double click or add another arc with additional mouse clicks. Furthermore pay attention, to the status bar and the change from select and insert modes. 'Insert' 'Rectangle' Symbol: With the command you can insert a rectangle as an element into your present visualization. 'Insert' 'Rounded Rectangle' Symbol: With the command you can insert a rectangle with rounded corners as an element in your present visualization. 'Insert' 'Ellipse' Symbol:
With the command you can insert a circle or an ellipse as an element in your present visualization. Insert' 'Polygon' Symbol: With the command you can insert a polygon as an element in your present visualization. Insert' 'ґPolyline' Symbol: With the command you can insert a polyline as an element in your present visualization. Insert' 'Curve' Symbol: With the command you can insert a Bezier curve as an element into your current visualization. Insert' 'Pie' Symbol: TX1200 260 Version: 1.3