PMAC Product Guide DWE1000 RET With I9=1: I125 ; Request address I-variable value I125=49152 ; PMAC reports whole statement, in decimal M101-> ; Request M-Variable definition M101->X:$C001,24,S ; PMAC reports whole statement LIST PROG 1 ; Request listing of program LINEAR ; PMAC reports program long form X10 DWELL1000 RETURN With I9=2: I125 ; Request address I-variable value $C000 ; PMAC reports just value, in hexadecimal With I9=3: I125 ; Request address I-variable value I125=$C000 ; PMAC reports whole statement, in hexadecimal I13 Programmed Move Segmentation Time Range: 0 .. 8,388,607 Default: 0 Units:
msec When greater than zero, this parameter puts PMAC into a mode (segmentation mode) where all LINEAR and CIRCLE moves are done as a continuous cubic spline in which the move segments are of the time length specified by the parameter in this variable (this is not the same thing as SPLINE mode moves). This mode is required for applications using CIRCLE mode moves. Segmentation mode (I13 greater than 0) is required to support any of the following PMAC features: • Circular interpolation • Cutter radius compensation • / Program stop command • \ Program hold command • Rotary buffer blend on-the-fly Typical values of I13 for segmentation mode are 5 to 10 msec.
The smaller the value, the tighter the fit to the true curve, but the more computation is required for the moves and the less is available for background tasks. If I13 is set too low, PMAC will not be able to do all of its move calculations in the time allotted and it will stop the motion program with a run-time error. If none of these features is required, keep I13 at 0. Note: When I13=0, moves are done without this ongoing spline technique and CIRCLE mode moves are done as LINEAR mode moves. I-Variables 101