omron — <CONTROL-F>

PMAC Product Guide Function: Report all coordinate system status words Scope: Global Syntax: ASCII Value 3D, $03 This command causes PMAC to report the status words for all of the coordinate systems to the host in hexadecimal ASCII form, 12 characters per coordinate system starting with coordinate system 1 with the characters for each coordinate system separated by spaces. The characters reported for each coordinate system are the same as if the ?? command had been issued for that coordinate system. The detailed meanings of the individual status bits are shown under the ?? command description.

For multiple cards on a single serial daisy-chain, this command affects only the card currently addressed in software (by the @n command). Example: A80020020000 A80020020000 A80020020000 A80020020000 A80020000000 A80020000000 A80020000000 A80020000000 Function : Disable all PLC programs Scope : Global Syntax : ASCII Value 4D; $04 This command causes all PLC programs to be disabled (i.e. stop executing). This is the equivalent of DISABLE PLC 0..31 and DISABLE PLCC 0..31 . It is useful especially if a CMD or SEND statement in a PLC has run amok. For multiple cards on a single serial daisy chain, this command affects all cards on the chain, regardless of the current software addressing.

Example: TRIGGER FOUND TRIGTRIGER FOTRIGGER FOUND TRTRIGTRIGGER FOUND (Out-of-control SEND message from PLC) ......... (Command to disable the PLCs) ............................ (No more messages; can now edit PLC) Function : Report following errors for all motors. Scope : Global. Syntax : ASCII Value 6D; $06 This command causes PMAC to report the following errors of all motors to the host. The errors are reported in an ASCII string, each error scaled in counts, rounded to the nearest tenth of a count. A space character is returned between the reported errors for each motor. Refer to the on-line F command for more detail as to how the following error is calculated.

For multiple cards on a single serial daisy chain, this command affects only the card currently addressed in software (by the @n command). Example: 0.5 7.2 -38.3 1.7 0 0 0 0 130 Online Commands