omron — <CONTROL-R>

PMAC Product Guide Function : Report positions of all motors Scope : Global Syntax : ASCII Value 16D; $10 This command causes the positions of all motors to be reported to the host. The positions are reported as an ASCII string, scaled in counts, rounded to the nearest tenth of a count, with a space character in between each motor’s position. The position window in the PMAC Executive program works by repeatedly sending the command and rearranging the response into the window. PMAC reports the value of the actual position register plus the position bias register plus the compensation correction register, and if bit 16 of Ix05 is 1 (handwheel offset mode), minus the master position register.

For multiple cards on a single serial daisy chain, this command affects only the card currently addressed in software (by the @n command). Example: 9999.5 10001.2 5.7 -2.1 0 0 0 0 Function : Quit all executing motion programs Scope : Global Syntax : ASCII Value 17D; $11 This command causes any and all motion programs running in any coordinate system to stop executing after the moves that have been calculated are finished already. Program execution may be resumed from this point with the R (run) or S (step) commands. For multiple cards on a single serial daisy chain, this command affects all cards on the chain, regardless of the current software addressing. Function :

Begin execution of motion programs in all coordinate systems Scope : Global Syntax : ASCII Value 18D; $12 This command is the equivalent of issuing the R (run) command to all coordinate systems in PMAC. Each active coordinate system (i.e. one that has at least one motor assigned to it) that is to run a program must be pointing to a motion program already (initially this is done with a B{prog num} command). For multiple cards on a single serial daisy chain, this command affects all cards on the chain, regardless of the current software addressing.

For a flash memory PMAC that is in bootstrap mode (powered up with E51 ON), the command puts PMAC into normal operational mode, but with factory default I-Variables, conversion table settings, and VME/DPRAM addresses. Example: &1B1&2B500 Online Commands 133