PMAC Product Guide Function : Kill all motors Scope : Global Syntax : ASCII Value 11D; $0B This command kills all motor outputs by opening the servo loop, commanding zero output, and taking the amplifier enable signal (AENA n ) false (polarity is determined by jumper E17) for all motors on the card. If any motion programs are running, they will be aborted automatically.
(For the motor-specific K (kill) command, if the motor is in a coordinate system that is executing a motion program, the program execution must be stopped with either an A (abort) or Q (quit) command before PMAC will accept the K command.) For multiple cards on a single serial daisy chain, this command affects all cards on the chain, regardless of the current software addressing. Function : Enter command line Scope : Gobal Syntax : ASCII Value 13D; $0D ( ) This character, commonly known as (carriage return), causes the alphanumeric characters in the PMAC’s command-line-receive buffer to be interpreted and acted upon.
(Control-character commands do not require a character to execute.) Note that for multiple PMACs daisy-chained together on a serial interface, this will act on all cards simultaneously, not just the software-addressed card. For simultaneous action on multiple cards, it is best to load up the command-line-receive buffers on all cards before issuing the character. Example: #1J+ P1 @0&1B1R@1&1B7R (This causes card 0 on the serial daisychain to ............................ have its CS 1 execute PROG 1 and card 1 to ............................ have its CS 1 execute PROG 7 simultaneously.) Function : Feed hold on all coordinate systems Scope : Global Syntax :
ASCII Value 15D; $0F This command causes all coordinate systems in PMAC to undergo a feed hold. A feed hold is much like a %0 command where the coordinate system is brought to a stop without deviating from the path it was following, even around curves. However, with a feed hold, the coordinate system slows down at a slew rate determined by I x 95, and can be started up again with an R (run) command. The system then speeds up at the rate determined by I x 95, until it reaches the desired % value (from internal or external timebase). From then on, any timebase changes occur at a rate determined by I x 94.
For multiple cards on a single serial daisy chain, this command affects all cards on the chain, regardless of the current software addressing. On a flash memory PMAC that is in bootstrap mode (powered up with E51 ON), the command puts PMAC into its firmware reload command. All subsequent characters sent to PMAC are interpreted as bytes of machine code for PMAC’s operational firmware, overwriting the existing operational firmware in flash memory. 132 Online Commands