PMAC Product Guide $ Function : Reset motor Scope : Motor specific Syntax : $ This command causes PMAC to initialize the addressed motor, performing any required commutation phasing and full reading of an absolute position sensor, leaving the motor in a closed-loop zero-velocity state. (For a non-commutated motor with an incremental encoder, the J/ command may also be used.) This command is necessary to initialize a PMAC-commutated motor after power-up/reset if Ix80 for the motor is set to 0. If Ix80 is 1, the initialization will be done automatically during the power-up/reset cycle. This command will not be accepted if the motor is executing a move. Example: I180 ..................
; Request value of #1 power-on mode variable 0 .......................... ; PMAC responds with 0; powers on un-phased and killed $$$ ..................... ; Reset card; motor is left in killed state #1$ ..................... ; Initialize motor, phasing and reading as necessary $$$ Function : Full card reset Scope : Global Syntax : $$$ This command causes PMAC to do a full card reset. The effect of $$$ is equivalent to that of cycling power on PMAC, or taking the INIT/ line low, then high. With jumper E51 in its default state (OFF for PMAC-PC, -Lite, -VME, ON for PMAC-STD), this command does a standard reset of the PMAC.
On PMACs without the Option CPU section (not option 4A, 5A, or 5B), I-Variable values, conversion-table settings, and DPRAM and VME bus addresses stored in permanent memory (EAROM) by the last SAVE command are reloaded into active memory (RAM). All information stored in battery backed RAM such as P-Variable and Q-Variable values, M-Variable definitions, and motion and PLC programs are not changed by this command. On PMACs with the Option CPU section (option 4A, 5A, or 5B), PMAC copies the contents of the flash memory into active memory during a normal reset cycle, overwriting any current contents.
This means that anything changed in PMAC’s active memory that was not saved to flash memory will be lost. Even the last saved P-Variable and Q-Variable values, M-Variable definitions, and motion and PLC programs are copied from flash to RAM during the reset cycle. With jumper E51 in non-default state (ON for PMAC-PC, -Lite, -VME, OFF for PMAC-STD), this command does a reset and re-initialization of the PMAC. On PMACs without the Option CPU section (not option 4A, 5A, or 5B), factory default I-Variable values, conversion-table settings, and DPRAM and VMEbus addresses stored in the firmware (EPROM) are copied into active memory (RAM).
(Values stored in EAROM are not lost; they are simply not used.) On PMACs with the Option CPU section (option 4A, 5A, or 5B), PMAC enters a special re-initialization mode called bootstrap mode that permits the downloading of new firmware. In this bootstrap mode, there are very few command options. To bypass the download operation in this mode, send a character to PMAC. This puts PMAC in the normal operational mode with the existing firmware. Factory default values for I-Variables, conversion table settings, and bus addresses for DPRAM and VME are copied from the firmware section of flash memory into active memory.
The saved values of these values are not used, but they are still kept in the user section of flash memory. Online Commands 139