omron — Second Word Returned (Y:$0817, Y:$08D7, etc.)

PMAC Product Guide Eighth Character Returned: Bit 19 Fatal Following Error: This bit is 1 when a Bit 23 Z-Axis Used in Feedrate Calculations: This bit is 1 if this axis is used in the vector feedrate calculations for F-based moves in the coordinate system; it is 0 if this axis is not used. See the FRAX command. Bit 22 Z-Axis Incremental Mode: This bit is 1 if this axis is in incremental mode -- moves specified by distance from the last programmed point. It is 0 if this axis is in absolute mode -- moves specified by end position, not distance. See the INC and ABS commands. Bit 21 Y-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 20 Y-Axis Incremental Mode:

(See bit 22 description.) Second Character Returned: Bit 19 X-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 18 X-Axis Incremental Mode: (See bit 22 description.) Bit 17 W-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 16 W-Axis Incremental Mode: (See bit 22 description.) Third Character Returned: Bit 15 V-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 14 V-Axis Incremental Mode: (See bit 22 description.) Bit 13 U-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 12 U-Axis Incremental Mode: (See bit 22 description.) Fourth Character Returned: Bit 11 C-Axis Used in Feedrate Calculations:

(See bit 23 description.) Bit 10 C-Axis Incremental Mode: (See bit 22 description.) Bit 9 B-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 8 B-Axis Incremental Mode: (See bit 22 description.) Fifth Character Returned: Bit 7 A-Axis Used in Feedrate Calculations: (See bit 23 description.) Bit 6 A-Axis Incremental Mode: (See bit 22 description.) Bit 5 Radius Vector Incremental Mode: This bit is 1 if circle move radius vectors are specified incrementally (i.e. from the move start point to the arc center). It is 0 if circle move radius vectors are specified absolutely (i.e. from the XYZ origin to the arc center). See the INC (R) and ABS (R) commands.

Bit 4 Continuous Motion Request: This bit is 1 if the coordinate system has requested of it a continuous set of moves (e.g. with an R command). It is 0 if this is not the case (e.g. not running program, Ix92=1, or running under an S command). Sixth Character Returned: Bit 3 Move-Specified-by-Time Mode: This bit is 1 if programmed moves in this coordinate system are currently specified by time (TM or TA) and the move speed is derived. It is 0 if programmed moves in this coordinate system are currently specified by feedrate (speed; F) and the move time is derived. Online Commands 149