omron — Second Word Returned (Y:$0817, Y:$08D7, etc.)

PMAC Product Guide Ninth Character Returned: Bit 15 Delayed Calculation Flag: (for internal use) Bit 14 End of Block Stop: This bit is 1 when a motion program running in the currently addressed Coordinate System is stopped using the / command from a segmented move (Linear or Circular mode with I13 > 0). Bit 13 Synchronous M-Variable One-Shot: (for internal use) Bit 12 Dwell Move Buffered: (for internal use) Tenth Character Returned : Bit 11 Cutter Comp Outside Corner: This bit is 1 when the coordinate system is executing an added outside corner move with cutter compensation on. It is 0 otherwise. Bit 10 Cutter Comp Move Stop Request:

This bit is 1 when the coordinate system is executing moves with cutter compensation enabled and has been asked to stop move execution. This is primarily for internal use. Bit 9 Cutter Comp Move Buffered: This bit is 1 when the coordinate system is executing moves with cutter compensation enabled and the next move has been calculated and buffered. This is primarily for internal use. Bit 8 Pre-jog Move Flag: This bit is 1 when any motor in the coordinate system is executing a jog move to pre-jog position ( J= command). It is 0 otherwise. Eleventh Character Returned: Bit 7 Segmented Move in Progress:

This bit is 1 when the coordinate system is executing motion program moves in segmentation mode (I13>0). It is 0 otherwise. This is primarily for internal use. Bit 6 Segmented Move Acceleration: This bit is 1 when the coordinate system is executing motion program moves in segmentation mode (I13>0) and accelerating from a stop. It is 0 otherwise. This is primarily for internal use. Bit 5 Segmented Move Stop Request: This bit is 1 when the coordinate system is executing motion program move in segmentation mode (I13>0) and it is decelerating to a stop. It is 0 otherwise. This is primarily for internal use. Bit 4 PVT / SPLINE Move Mode:

This bit is 1 if this coordinate system is in either PVT move mode or SPLINE move mode. (If bit 0 of this word is 0, this means PVT mode; if bit 0 is 1, this means SPLINE mode.) This bit is 0 if the coordinate system is in a different move mode ( LINEAR , CIRCLE , or RAPID ). See the table below. Twelfth Character Returned: Bit 3 Cutter Compensation Left: This bit is 1 if the coordinate system has cutter compensation on, and the compensation is to the left when looking in the direction of motion. It is 0 if compensation is to the right, or if cutter compensation is off. Bit 2 Cutter Compensation On: This bit is 1 if the coordinate system has cutter compensation on.

It is 0 if cutter compensation is off. Bit 1 CCW Circle\Rapid Mode: When bit 0 is 1 and bit 4 is 0, this bit is set to 0 if the coordinate system is in CIRCLE1 (clockwise arc) move mode and 1 if the coordinate system is in CIRCLE2 (counterclockwise arc) move mode. If both bits 0 and 4 are 0, this bit is set to 1 if the coordinate system is in RAPID move mode. Otherwise this bit is 0. See the table below. Online Commands 151