PMAC Product Guide BUFFER COMMANDS The PMAC motion controller is rich in features and expansion capabilities. Because this manual illustrates the implementation of PMAC in a typical application, some of the PMAC advanced buffer commands are not described. Further information of all the PMAC buffer commands can be obtained from the PMAC Software Reference manual. {axis}{data}[{axis}{data}...] Function : Position-only move specification Type : Motion program (PROG and ROT) Syntax : axis}{data}[{axis}{data}...] where {axis} is the character specifying which axis (X, Y, Z, A, B, C, U, V, W).
{data} is a constant (no parentheses) or an expression (in parentheses) representing the end position or distance. [{axis}{data}...] is the optional specification of simultaneous movement for more axes. This is the basic PMAC move specification statement. It consists of one or more groupings of an axis label and its associated value. The value for an axis is scaled (units determined by the axis definition statement); it represents a position if the axis is in absolute (ABS) mode, or a distance if the axis is in incremental (INC) mode. The order in which the axes are specified does not matter. This command tells the axes where to move. It does not tell them how to move there.
Other program commands and parameters define how. These must be set up ahead of time. The type of motion a given motion command causes is dependent on the mode of motion and the state of the system at the beginning of the move. Examples: X1000 X(P1+P2) Y(Q100+500) Z35 C(P100) X1000 Y1000 A(P1) B(P2) C(P3) X(Q1*SIN(Q2/Q3)) U500 {axis}{data}:{data} [{axis}{data}:{data}...] Function : Position and velocity move specification Type : Motion program (PROG and ROT) Syntax : {axis}{data}:{data} [{axis}{data}:{data}...] where {axis} is the character specifying which axis (X, Y, Z, A, B, C, U, V, W).
{data} is a constant (no parentheses) or an expression (in parentheses) representing the end position or distance. :{data} represents the ending velocity. [{axis}{data}:{data}...] is the optional specification of simultaneous movement for more axes. Buffer Commands 197