PMAC Product Guide This command causes a move of the A-axis. (See {axis}{data} descriptions, in this section.) Examples: A10 A(P23) A25 B10 Z35 A(20*SIN(Q5)) ABS Function : Absolute move mode Type : Motion program (PROG and ROT) Syntax : ABS [({axis}[,{axis}...])] where {axis} is a character (X,Y,Z,A,B,C,U,V,W) representing the axis to be specified, or the character R to specify radial vector mode The ABS command without arguments causes all subsequent positions in motion commands for all axes in the coordinate system running the motion program to be treated as absolute positions. This is known as absolute mode and it is the power-on default condition.
An ABS statement with arguments causes the specified axes in the coordinate system running the program to be in absolute mode and all others stay the way they were before. If R is specified as one of the axes, the I, J, and K terms of the circular move radius vector specification will be specified in absolute form (i.e. as a vector from the origin, not from the move start point). An ABS command without any arguments does not affect this vector specification. The default radial vector specification is incremental. If no motion program buffer is open when this command is sent to PMAC, it will be executed as an on- line coordinate system command. Examples:
ABS(X,Y) ABS ABS(V) ABS(R) ADDRESS Function : Motor/coordinate system modal addressing Type : PLC programs 1 to 31 only Syntax : ADDRESS [#{constant}][&{constant}] ADR [#{constant}][&{constant}] where {constant} is an integer constant from 1 to 8 representing the motor (#) number or the coordinate system (&) number to be addressed. When executed, this statement sets the motor and/or coordinate system that will be addressed by this particular PLC program when it commands motor- or coordinate-system-specific commands with no addressing in those commands. The addressed coordinate system also controls which set of Q-Variables is accessed, even for ATAN2 functions which use Q0 automatically.
Buffer Commands 201