PMAC Product Guide is negative, PMAC will compute the long arc path (>= 180 o ). It is not possible to specify a full circle in one command with the R vector specifier. The plane for the circular arc must have been defined by the NORMAL command (the default -- NORMAL K-1 -- defines the XY plane). This command can define only planes in XYZ-space, which means that only the X, Y, and Z axes can be used for circular interpolation. Other axes specified in the same move command will be interpolated linearly to finish in the same time.
The direction of the arc to the destination point (clockwise or counterclockwise) is controlled by whether the card is in CIRCLE1 (clockwise) or CIRCLE2 (counterclockwise) mode. The sense of clockwise in the plane is determined by the direction of the NORMAL vector to the plane. If the destination point is a different distance from the center point than the starting point, the radius is changed smoothly through the course of the move, creating a spiral. This is useful in compensating for any round off errors in the specifications.
However, if the distance from either the starting point or the destination point to the center point is zero, an error condition will be generated and the program will stop. If the vector from the starting point to the center point does not lie in the circular interpolation plane, the projection of that vector into the plane is used. If the destination point does not lie in the same circular interpolation plane as the starting point, a helical move is done to the destination point.
If the destination point (or its projection into the circular interpolation plane containing the starting point) is the same as the starting point, a full 360 o arc is made in the specified direction (provided that IJK vector specification is used). In this case, only the vector needs to be specified in the move command, because for any axis whose destination is not specified, the destination point is taken to be the same as the starting point automatically. If no vector and no radial magnitude is specified in the MOVE command, a linear move will be done to the destination point, even if the program is in circular mode Note:
PMAC performs arc moves by segmenting the arc and performing the best cubic fit on each segment. I-Variable I13 determines the time for each segment. I13 must be set greater than zero to put PMAC into this segmentation mode in order for arc moves to be done. If I13 is set to zero, circular arc moves will be done in linear fashion. Examples: X5000 Y3000 I1000 J1000 X(P101) Z(P102) I(P201) K(P202) X10 I5 X10 Y20 C5 I5 J5 Y5 Z3 R2 J10 ; Specifies a full circle of 10 unit radius A{data} Function : A-Axis move Type : Motion program (PROG or ROT) Syntax : A{data} where {data} is a floating-point constant or expression representing the position or distance in user units for the U-axis.
200 Buffer Commands