PMAC Product Guide The trigger for a motor can be either a hardware input trigger if bit 17 of Ix03 is 0, or the motor warning following error status bit if bit 17 of Ix03 is 1 (bit 16 of Ix03 should also be set to 1 in this case). If a hardware input trigger is used, Encoder/Flag I-Variables 2 and 3 (e.g. I902 and I903) for the flag channel specified by Ix25 determine which edges of which flags cause the trigger. If the warning following error bit is used for torque-limited triggering, then Ix12 sets the size of the warning following error. The speed of the move, both before the trigger and after, is set by Ix22 if I50=0 or by Ix16 if I50=1. The acceleration is set by Ix19 to Ix21.
On the same line, some axes may be specified for normal untriggered RAPID moves that will execute simultaneously. If the move ends for a motor without a trigger being found, the trigger move status bit (bit 7 of the second motor status word returned on a ? command) is left set after the end of the move. If the trigger has been found, this bit is cleared to 0 at the end of the move. Examples: X1000^0 X10^-0.01 Y5.43^0.05 A(P1)^(P2) B10^200 C(P3)^0 X10 {axis}{data} [{axis}{data}...] {vector}{data} [{vector}{data}...] Function : Circular arc move specification Type :
Motion program (PROG and ROT) Syntax {axis}{data} [{axis}{data}...] {vector}{data} [{vector}{data}...] where {axis} is a character specifying which axis (X, Y, Z, A, B, C, U, V, W);. {data} is a constant (no parentheses) or an expression (in parentheses) representing the end position or distance. [{axis}{data}...] is the optional specification of simultaneous movement for more axes. {vector} is a character (I, J, or K) specifying a vector component (parallel to the X, Y, or Z axis, respectively) to the center of the arc; or the character R specifying the magnitude of the vector. {data} specifies the magnitude of the vector component.
[{vector}{data}...] is the optional specification of more vector components. For a blended circular mode move, both the move endpoint and the vector to the arc center are specified. The endpoint is specified just as in a LINEAR mode move, either by position (referenced to the coordinate system origin), or distance (referenced to the starting position). The center of the arc for a circular move must be specified also in the MOVE command. Usually, this is done by defining the vector to the center.
This vector can either be referenced to the starting point of the move (incremental radial vector mode -- the default, or if an INC (R) command has been given), or it can be referenced to the coordinate system origin (absolute radial vector mode -- if an ABS (R) command has been given). Alternatively, just the magnitude of the vector to the center can be specified with R{data} on the command line. If this is the case, PMAC will calculate the location of the center itself. If the value specified by {data} is positive, PMAC will compute the short arc path to the destination ( o ); if it Buffer Commands 199