omron — AROT{constant}

PMAC Product Guide In motion programs, there can be compound conditions within one program line, but not across multiple program lines, so this statement is not permitted in motion programs. Note: This logical AND command which acts on condition, should not be confused with the bit-by-bit & (ampersand) operator that acts on values. Examples: IF (M11=1) ; This branch will start a motion program running AND (M12=1) ; on a cycle where inputs M11 and M12 are 1 and AND (M21=0) ; M21 is still zero. Note that M21 is immediately CMD"R" ; set to one so the run command will not be given M21=1 ; again in the next cycle. ENDIF AROT{constant} Function :

Absolute rotation/scaling of X, Y, and Z axes Type : Motion program (PROG and ROT) Syntax : AROT{constant} where {constant} is an integer representing the number of the first of nine consecutive Q-Variables to be used in the rotation/scaling matrix. This command loads the currently selected (with TSEL ) transformation matrix for the coordinate system with rotation/scaling values contained in the nine Q-Variables starting with the specified one. This has the effect of renaming the current commanded X, Y, and Z axis positions (from the latest programmed move) by multiplying the XYZ vector by this matrix.

The rotation and scaling is done relative to the base XYZ coordinate system, defined by the axis definition statements. The math performed is: [Xrot Yrot Zrot] T = [Rot Matrix] [Xbase Ybase Zbase] T This command does not cause any movement of any axes; it simply renames the present positions. Note: When using this command to scale the coordinate system, do not use the radius center specification for circle commands. The radius does not get scaled. Use the I , J , K vector specification instead. Examples: Create a 3x3 matrix to rotate the XY plane by 30 degrees about the origin:

Q40=COS(30) Q41=SIN(30) Q42=0 Q43=-SIN(30) Q44=COS(30) Q45=0 Q46=0 Q47=0 Q48=1 AROT 40 ; Implement the change Create a 3x3 matrix to scale the XYZ space by a factor of 3 Q50=3 Q51=0 Q52=0 Q53=0 Q54=3 Q55=0 Q56=0 Q57=0 Q58=3 AROT 50 ; Implement the change Buffer Commands 203