PMAC Product Guide DELAY{data} Function : Delay for specified time Type : Motion program Syntax : DELAY{data} DLY{data} where {data} is a floating-point constant or expression, specifying the delay time in milliseconds. This command causes PMAC to keep the command positions of all axes in the coordinate system constant (no movement) for the time specified in {data} . There are three differences between DELAY and DWELL . 1. If DELAY comes after a blended move, the TA deceleration time from the move occurs within the DELAY time, not before it. 2.
The actual time for DELAY does varies with a changing time base (current % value, from whatever source), whereas DWELL always uses the fixed time base (%100). 3. PMAC pre-computes upcoming moves (and the lines preceding them) during a DELAY , but it does not do so during a DWELL . A DELAY command is equivalent to a zero-distance move of the time specified in milliseconds. As for a move, if the specified DELAY time is less than the acceleration time currently in force ( TA or 2* TS ), the delay will be for the acceleration time, not the specified DELAY time. Examples: DELAY750 DELAY(Q1+100) DISABLE PLC {constant}[,{constant}...] Function : Disable PLC programs Type :
Motion program (PROG or ROT), PLC program Syntax : DISABLE PLC {constant}[,{constant}...] DISABLE PLC {constant}[..{constant}] DIS PLC {constant}[,{constant}...] DIS PLC {constant}[..{constant}] This command disables the operation of the specified PLC programs. The programs are specified by number and can be used singly, in a list separated by commas, or in a continuous range. Disabling a PLC cannot stop the PLC in the middle of a scan; it prevents it from starting the next scan. Examples: DISABLE PLC 1 DISABLE PLC 4,5 DISABLE PLC 7..20 DIS PLC 3,8,11 DIS PLC 0..31 DISPLAY [{constant}] "{message}" Function : Display Text to Display Port Type :
Motion program (PROG and ROT), PLC program Syntax : DISPLAY [{constant}] "{message}" DISP [{constant}] "{message}" where {constant} is an integer value between 0 and 79 specifying the starting character number on the display; if no value is specified, 0 is used. 210 Buffer Commands