PMAC Product Guide Examples: TA100 TA(P20) TA(45.3+SQRT(Q10)) TINIT Function : Initialize selected transformation matrix Type : Motion program (PROG and ROT) Syntax : TINIT This command initializes the currently selected (with TSEL ) transformation matrix for the coordinate system by setting it to the identity matrix. This makes the rotation angle 0, the scaling 1, and the displacement 0, so the XYZ points for the coordinate system are as the axis definition statements created them. PMAC will still perform the matrix calculations, even though they have no effect.
TSEL0 should be used to stop the matrix calculations Subsequently, the matrix can be changed with the ADIS , IDIS , AROT , and IROT commands. Examples: TSEL 4 ; Select transformation matrix 4 TINIT ; Initialize it to the identity matrix IROT 71 ; Do incremental rotation/scaling with Q71-Q79 TM{data} Function : Set move time Type : Motion program Syntax : TM{data} where {data} is a floating-point constant or expression representing the move time in milliseconds. The maximum effective TM value is 2 23 msec. The minimum effective TM value is 1 msec. This command establishes the time to be taken by subsequent LINEAR or CIRCLE mode (blended) motions.
It overrides any previous TM or F statement, and is overridden by any subsequent TM or F statement. It is irrelevant in RAPID , SPLINE , and PVT move modes, but the latest value will stay active through those modes for the next return to blended moves. The acceleration time is the minimum time for a blended move; if the specified move time is shorter than the acceleration time, the move will be done in the acceleration time instead. This will slow down the move. If TM controls the move time it must be greater than the I13 time and the I8 period. Note:
For LINEAR mode moves with I13=0 (no move segmentation), if the commanded velocity (distance/TM) of any motor in the move exceeds its maximum limit (Ix16), all motors in the coordinate system will be slowed down in proportion so that no motor exceeds its limit. Examples: TM30 TM47.635 TM(P1/3) 238 Buffer Commands