PMAC Product Guide WHILE ({condition}) {action} (Valid in motion and PLC programs) With no statement following on the same line, it will execute statements on subsequent lines down to the next ENDWHILE statement. WHILE ({condition}) {statement} [{statement} ...] ENDWHILE If a WHILE loop in a motion program has no move, DWELL , or DELAY inside, PMAC will attempt to execute the loop twice (while true) each real-time interrupt cycle (stopped from more loops only by the "double-jump-back" rule), much like a PLC0. This can starve the background tasks for time, possibly even tripping the watchdog timer.
PMAC will not attempt to blend moves through such an empty WHILE loop if it finds the loop condition true twice or more. In PLC programs, extended compound WHILE conditions can be formed on multiple program lines through use of AND and OR commands on the program lines immediately following the WHILE command itself (this structure is not available in motion programs). Conditions in each program line can be either simple or compound. AND and OR operations within a program line take precedence over AND and OR operations between lines. Examples: WHILE (P20=0) ... ENDWHILE WHILE (Q10 1) ...
ENDWHILE WHILE (M11=0) WAIT ; sit until input goes true INC WHILE (M11=0 OR M12=0) X100 ; increment until 2 inputs true To do the equivalent of a For/Next loop: P1=0 ; Initialize loop counter WHILE (P1 ; Loop until counter exceeds limit X1000 ; Perform action to be repeated P1=P1+1 ; Increment loop counter ENDWHILE ; Loop back To do a timed wait in a PLC program, use the servo cycle counter as timer:
P90=16777216 ; Counter rollover value (2^24) P91=M0 ; Store starting value of M0 (X:$0) counter P92=0 ; Time elapsed so far WHILE (P92 ; Loop until past specified time P92=(M0-P91)%P90 ; Calculate time elapsed ; Modulo (%) operation to handle rollover ENDWHILE ; Loop back To do extended compound conditions in a PLC program: WHILE (M11=1 AND M12=1) OR (M13=1 AND M14=1) AND (P1>0) ... ENDWHILE 242 Buffer Commands