User Manual of EM730 Series Inverter 314 F18.02 Reserved 0x1202 F18.03 Estimate feedback frequency Display the estimated feedback frequency in the SVC control mode. Scope: 0.00 to upper frequency limit. ★: This parameter will be updated promptly in the SVC control mode. Hz 0x1203 F18.04 Output torque Display the current output torque of the inverter. Scope: -200.0 ~ 200.0. % 0x1204 F18.05 Torque setting Display the current set torque of the inverter. Scope: -200.0 ~ 200.0. ★: This parameter will be updated promptly in the torque control mode. % 0x1205 F18.06 Output current Display the current output current of the inverter.
Depending on the rated power level of the motor, the range is as follows: 0.00 to 650.00 (rated power of motor: ≤75 kW) 0.0 to 6500.0 (rated power of motor: > 75 kW) A 0x1206 F18.07 Output current percentage Display the current output current as a percentage (relative to the rated current of the inverter). Range: 0.0 to 300.0. % 0x1207 F18.08 Output voltage Display the current output voltage of the inverter. Scope: 0.0 ~ 690.0. V 0x1208 F18.09 DC bus voltage Display the current bus voltage. Scope: 0 - 1200. V 0x1209 F18.10 Simple PLC running times When the auxiliary frequency source B is involved in setting (F00.06 ≠0), the setting mode is “11:
simple PLC” (F00.05=11) and the simple PLC runs in the mode of limited cycles (F08.15=1/2), the real-time number of cycles will be displayed. “0” indicates that the first operation is being performed, and “1” indicates that the first operation has been completed and the second operation is being carried out. Scope: 0 - F08.16. 0x120A F18.11 Simple PLC operation stage When the auxiliary frequency source B is involved in setting (F00.06 ≠0), and the setting mode is “11: simple PLC” (F00.05=11), the real-time PLC running status will be displayed. Scope: 1-15, corresponding to the multi-segment speed 1 (F08.00) to multi-segment speed 15 (F08.14).
0x120B F18.12 PLC running time at the current stage When the auxiliary frequency source B is involved in setting (F00.06 ≠0) and the setting mode is “11: simple PLC” (F00.05=11), the PLC running time at the current stage will be displayed in a real-time manner. Scope: 0.0 to the set time of the corresponding segment (example: the time of the first segment is dependent on F08.20). s / min 0x120C F18.13 Reserved 0x120D