User Manual of EM760 High-Performance Inverter F00.13=2: AI2 * synthetic frequency of main and auxiliary channels F00.13=3: AI3 * synthetic frequency of main and auxiliary channels F00.13=4: AI4 * synthetic frequency of main and auxiliary channels The synthetic frequency is directly set to “AI (percentage) * synthetic frequency of main and auxiliary channels”. The 100.00% of AI1~AI4 is the percentage relative to the synthetic frequency of main and auxiliary channels. AI4 requires an extension card. For detailed settings of analog input, see 6.5.7 for details. F00.13=5:
High frequency pulse (PULSE) * synthetic frequency of main and auxiliary channels The synthetic frequency depends on “HDI (percentage) * synthetic frequency of main and auxiliary channels”. The high-speed pulse is input via the X7 terminal. When this channel is used, you need to set F02.06=40. The value 100.00% is the percentage relative to the synthetic frequency of main and auxiliary channels. For detailed settings ofhigh-speed pulses, see 6.5.3 for details. 6.2.2 Selection of main frequency source As shown below, it is necessary to comprehensively consider the digital terminal setting and its status during the setting of the main frequency source A.
Depending on the terminal settings, multi- segment speed operation can be performed or digital, analog, pulse or communication settings can be applied directly. If the terminals are unavailable, the current setting channel is determined by the function code F00.04, and final settings are obtained through UP/DOWN setting calculation. Fig. 6-5 Schematic Diagram of Setting of Main Frequency Source 78