Supermicro 4021M-T2R+ / 4021M-82R+ — Supermicro 4021M-T2R+ / 4021M-82R+ Server User & Service Manual PDF

Chapter 5: Advanced Serverboard Setup Power LED/Speaker On JD1, pins 1, 2, and 3 are for the power LED and pins 4 through 7 are for the speaker. See the tables on the right for pin defi nitions. Note: The speaker connector pins are for use with an external speaker. If you wish to use the onboard speaker, you should close pins 6 and 7 with a jumper. Overheat LED Connect an LED to the JOH1 header to provide warning of chassis over- heating. See the table on the right for pin defi nitions. Chassis Intrusion A Chassis Intrusion header is located at JL1. Attach the appropriate cable to inform you of a chassis intrusion. Wake-On-LAN The Wake-On-LAN header is desig- nated JWOL.

See the table on the right for pin defi nitions. You must have a LAN card with a Wake-On-LAN connector and cable to use the Wake- On-LAN feature. (Note: Wake-On-LAN from S3, S4, S5 are supported by LAN1.

LAN2 sup- ports Wake-On-LAN from S1 only.) 5-17 PWR LED Connector Pin Defi nitions (JD1) Pin# Defi nition 1 +Vcc 2 Control 3 Control Speaker Connector Pin Defi nitions (JD1) Pin# Defi nition 4 Red wire, +5V 5 No connection 6 Buzzer signal 7 Speaker data Overheat LED Pin Defi nitions (JOH1) Pin# Defi nition 1 3.3V 2 OH Active Chassis Intrusion Pin Defi nitions (JL1) Pin# Defi nition 1 Battery voltage 2 Intrusion signal Wake-On-LAN Pin Defi nitions (JWOL) Pin# Defi nition 1 +5V Standby 2 Ground 3 Wake-up