S uper W orkstation 5046A-X User's Manual 5-6 Installing Memory Modules Note : Check the Supermicro web site for recommended memory modules. CAUTION Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. Installing & Removing DIMMs Press down the release tabs Insert the desired number of DIMMs into the memory 1. slots, starting with DIMM #1A. For best performance, please use the memory modules of the same type and speed in the same bank. See the DIMM Installa- tion Chart on the following page. Press down the release tabs on the ends of a 2. Insert & press a DIMM into the slot memory slot. Insert each DIMM module vertically into its slot.
Pay attention to the notch along the bottom of the module to prevent inserting the DIMM module incorrectly. Gently press down on the DIMM module until it snaps 3. into place in the slot. Repeat for all modules. Reverse the steps above to remove the DIMM mod- 4. ules from the motherboard. Figure 5-3. DIMM Installation Notch Notch To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom. Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Note: Notch should align with the receptive key point on the slot.
Release Tab Release Tab Top View of DDR3 Slot 5-8