— Supermicro SuperWorkstation 5046A-X User's Manual (1.0a)

Chapter 5: Advanced Serverboard Setup CD and Audio FP A 4-pin CD header (CD-IN) and an auxiliary header (Audio FP) allow you to use the onboard sound for audio CD playback. Connect an audio cable from your CD drive to the header that fi ts your cable's connector. Only one header can be used at any one time. See the tables at right for pin defi ni- tions. Front Panel Audio Control When front panel headphones are plugged in, the back panel audio output is disabled. This is done through the FP Audio header (Audio FP). If the front panel interface card is not connected to the front panel audio header, jumpers should be installed on pin pairs 1-2, 5-6, and 9-10 of the Audio FP header.

If these jumpers are not installed, the back panel line out connector will be disabled, and pin 1 of the microphone in will be left fl oating, which can lead to excessive back panel microphone noise and crosstalk. See the table at right for pin defi nitions. High Defi nition Audio (HDA) The C7X58 features a 7.1+2 Channel High Defi nition Audio (HDA) codec that Orange: CEN/LFE provides 10 DAC channels, simultane- Black: Back Surround ously supporting 7.1 sound playback and two channels of independent ste- reo sound output (multiple streaming) Grey: Side Surround through the front panel stereo out via the front L&R, rear L&R, center and subwoofer speakers.

This feature is activated with the software included in the CD-ROM that came with your moth- erboard. Sound is output through the Line In, Line Out and MIC jacks. 5-17 Audio Input CD Header Pin Defi nitions (CD-IN) Pin# Defi nition 1 Left Stereo Signal 2 Ground 3 Ground 4 Right Stereo Signal Front Panel Audio Pin Defi nitions (Audio FP) Pin# Defi nition 1 MIC L _ 2 Audio Ground 3 MIC R _ 4 FP Audio Detect 5 Line 2 R _ _ 6 Ground 7 FP Jack Detect _ 8 Key 9 Line 2 L _ _ 10 Ground