Chapter 5: Advanced Serverboard Setup LAN1/LAN2 Enable/Disable Change the setting of jumper JPL1 or JPL2 to enable or disable the LAN1 and LAN2 Ethernet ports, respectively. See the table on the right for jumper set- tings. The default setting is enabled. Audio Enable/Disable JPAC enables or disables the onboard audio connections. See the table on the right for jumper settings. The default setting is Enabled. SMBus to PCI/PCI-E Slots Jumpers JI 2 C1 and JI 2 C2 allow you to connect the PCI slots to the System Management Bus (I 2 C). The default setting is disabled. See the table on the right for jumper settings. Watch Dog Enable/Disable JWD controls the Watch Dog function.
Watch Dog is a system monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause WD to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be en- abled in BIOS. Note: When enabled, the user needs to write their own application software in order to disable the Watch Dog Timer.
5-21 LAN1/LAN2 Enable/Disable Jumper Settings (JPL1/JPL2) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled Audio Enable/Disable Jumper Settings (JP5) Pin# Defi nition 1-2 Enabled 2-3 Disabled SMBus to PCI Slots Jumper Settings (JI2C1/JI2C2) JI2C1/ JI2C2 Setting Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog Jumper Settings (JWD) Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled