S uper W orkstation 5046A-X User's Manual USB Wake-Up Enable/Disable Use the JPUSB1/2 jumpers to allow the system to be "Woken Up" via USB devices by pressing a key on the USB keyboard or by clicking the USB mouse of your system. These jumpers are used together with the USB Wake-Up function in the BIOS. Enable the jumper and the BIOS setting to use this feature. See the table on the right for jumper settings. Note : JPUSB1 is used for USB ports #0~7, and JPUSB2 is for Front Panel USB ports #8, #9 and #10~11. The de- fault jumper setting is Enabled for JUSB1 and disabled for JUSB2.
However, when the USB function is Enabled in the BIOS, please be sure to remove those USB devices from the USB ports whose USB jumpers are set to Disabled before the system goes into the standby mode. IEEE 1394a Enable/Disable JPI1 allows the user to use the onboard IEEE 1394_1 and 1394_2 connections. Close pins 1-2 to use this function. The default setting is Enabled. 5-22 USB Wake-Up Enable/ Disable Jumper Set- tings (JUSB1/JUSB2) Pin# Defi nition 1-2 Enabled 2-3 Disabled 1394a Enable Jumper Settings Pin# Defi nition 1-2 Enabled (default) 2-3 Disabled