S uper W orkstation 5046A-X User's Manual C0 - Active. The CPU is processing instructions. C1 - Auto Halt. The core clock (CPU) is off. This is the most basic idle state. Some CPUs support C1E (C1 Enhanced) for lower power consumption. C2 - Stop Clock. Both the core clock (CPU) and bus clocks (I/O) are off. C3 - Deep Sleep. The clock generator is off. C4 - Deeper Deep Sleep. Reduced VCC (Voltage supply). C6 - Cache Power Off. Power is turned off to all caches. C7 - Processor Specifi c. Leaves initialized Application Processor in a processor- specifi c low C-State. For Intel® Core i7™ processors, this is the lowest sup- ported C-State.
C1E Support This should be enabled in order to use the "Enhanced Halt State" feature. C1E cycle and voltage during a "Halt State". The options are Disabled and Enabled . signifi cantly reduces the CPU's power consumption by reducing the CPU's clock C-STATE Tech If enabled, C-State is set by the system automatically to either C2/C3/C4. The options are Disabled and Enabled . C-State package limit setting The selected option will be programmed into the C-State package limit register. The options are Auto , C1, C3, C6 and C7. C1 Auto Demotion When enabled, the CPU will conditionally demote C3/C6/C7 requests to C1 based on uncore auto-demote information. The options are Disabled and Enabled.
C3 Auto Demotion When enabled, the CPU will conditionally demote C6/C7 requests to C1 based on uncore auto-demote information. Available options are Disabled and Enabled. DCA This feature cooperates with Intel I/O AT (Acceleration Technology) to accelerate the performance of TOE devices. (Note: A TOE device is a specialized, dedicated processor that is installed on an add-on card or a network card to handle some or all packet processing of this add-on card. For this motherboard, the TOE device is built inside the ESB 2 South Bridge chip.) The options are Enabled and Disabled. 7-8