Chapter 2: Installation HDD LED The HDD LED connections are located on pins 13 and 14 of JF1. Attach a hard-drive LED cable to display HDD or SATA activities. Refer to the table on the right for pin defi nitions. Power LED Connector The Power LED connector is on pins 15 and 16 of JF1. See the table on the right for pin defi nitions. NMI Button The non-maskable interrupt button header is located on pins 19 and 20 of JF1. Refer to the table on the right for pin defi nitions. Universal Serial Bus Ports Two Universal Serial Bus ports (USB 2.0) are located beside the Keyboard and Mouse PS2 ports. One additional Type A port (USB6) is also included on the motherboard.
See the table on the right for pin defi nitions. USB Headers Four USB 2.0 headers (USB2/3 and USB4/5) are also included on the motherboard. These may be connected to provide front side access. A USB cable (not included) is needed for the connection. See the table on the right for pin defi nitions. Note: NC indicates no connection.
2-15 HDD LED Pin Defi nitions (JF1) Pin# Defi nition 13 Vcc 14 HDD LED Power LED Pin Defi nitions (JF1) Pin# Defi nition 15 3.3V 16 Power LED NMI Button Pin Defi nitions (JF1) Pin# Defi nition 19 NMI 20 Ground Universal Serial Bus Ports Pin Defi nitions (USB 0/1, USB6) USB0/1 Pin# Defi nition USB6 Pin# Defi nition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground Universal Serial Bus Headers Pin Defi nitions (USB2/3, USB4/5) JUSB2, JUSB3 Pin# Defi nition Pin# Defi nition 1 +5V 2 +5V 3 PO- 4 PO- 5 PO+ 6 PO+ 7 Ground 8 Ground 9 Key 10 NC